Stormcure Glue Curing Accelerator 250ml

£19.99
In stock
Content

1 x 250ml Stormcure glue curing accelerator

Description
SKU
SC250
Typical Uses

Mix a small amount of this accelerator with Stormsure Flexible Repair Adhesive and it will help reduce the cure time from 10-12 hours down to about 1-2 hours.

Content

1 x 250ml Stormcure glue curing accelerator

Description

Mix a small amount of this accelerator with Stormsure Flexible Repair Adhesive and it will help reduce the cure time from 10-12 hours down to about 1-2 hours.

Also you can use it to thin the adhesive so it may be applied with a paint brush. For waterproofing stitched seams you should make a mixture with only 25% adhesive and 75% accelerator. Mix quickly and thoroughly and paint it onto the surface. The mixture will "wick" its way into the tiny needle holes and cure inside the thread thus blocking the hole.

Some drysuit manufacturers use 3 layers. The first is about 85% accelerator, The second layer is 25% and the third layer is 5% accelerator. This combination should outlast the life of the suit.

Use it to preclean a surface and clean up afterwards.

NOT to be sent by MAIL. Courier Only

Typical Uses

Mix a small amount of this accelerator with Stormsure Flexible Repair Adhesive and it will help reduce the cure time from 10-12 hours down to about 1-2 hours.

Write Your Own Review
You're reviewing:Stormcure Glue Curing Accelerator 250ml